At the Israeli Quantum Computing Center, a single extra check before a quantum calculation helped cut a superconducting qubit’s average error rate by about 54%. The measurement tells researchers which of two possible resonance frequencies the qubit has at that moment, so they can tune its control signals before the next operations begin.

Quantum computers could one day tackle problems that are too difficult for today’s machines. But their basic units, called quantum bits or qubits, are easily disturbed. Even small changes in a qubit’s surroundings can make the signals controlling it less precise, raising the chance of mistakes. Finding practical ways to keep those signals in tune is an important step toward more reliable quantum computers.

The study was led by researchers at the University of Regensburg with international partners. They tested the technique on a superconducting quantum circuit at the Israeli Quantum Computing Center. The qubit was a tiny electrical circuit on a chip, controlled with microwave signals. Its resonance frequency—the frequency that determines which control signals work best—could switch unpredictably between two known values.

That switch did not mean the qubit had changed its computational state. Instead, the same physical device had taken on one of two possible frequencies. The shifts are linked to interactions with tiny defects in the material. When the active frequency changes, the old microwave controls may no longer guide the qubit as accurately.

To find out which frequency was active, the researchers first prepared the qubit in a quantum state and let it evolve briefly. Because its evolution differed at the two frequencies, a measurement at the end could distinguish between them. The team then used the result right away to adjust the control signals for the operations that followed. This kind of quick measurement-and-adjustment loop is called feedback.

Earlier work had shown that the two frequencies could be told apart. The new step was putting that information to use in real time. The researchers compared the qubit’s performance with and without feedback. Without adjustments, the quality of its operations varied substantially over time. With feedback, performance stayed more consistent and the operations had high fidelity, meaning they more closely matched the intended results.

The average error rate fell from about 0.14% without feedback to 0.065% with it, a reduction of roughly 54%. Compared with the largest error seen without feedback, the reduction reached 77%. The findings were published in Applied Physics Reviews.

The technique still depends on specific conditions: researchers must know the possible frequencies in advance, those frequencies must be distinct enough to tell apart, and the active frequency must stay steady long enough for the new controls to help. Even so, the experiment shows how one carefully timed measurement can make a real difference. Applying similar feedback methods under a wider range of conditions could help researchers keep quantum operations more dependable as they work toward larger quantum computers.